[[Tutorial]] * Change Log in v121029 (server) and v2.0.1 (viewer) [#sd271fa8] **ポートフォワーディング [#d171abe5] -サービスプロバイダ使用時に双方向のポートフォワーディング設定の必要がなくなった。(サービスプロバイダ使用時には-Lオプションを用いてサービスプロバイダで使用するポート番号のポートフォワーディングを別途行う必要がある。) ** Portforwarding [#bc5ab8c2] - Bi-directional portforwarding is not required anymore in SIGViewer. -- Another portforwarding is required for Service Provider with -L option to specify the port number which is used in the Service Provider. **メッセージ送受信関数 [#g19257a2] -メッセージ送信関数名sendMessage→sendMsg。 -メッセージ受信関数名onRecvMessage→onRecvMsg。 -同時に複数のエンティティにメッセージ送信可能となった。 ** APIs for sending and receiving messages are added/changed [#d9674b45] - sendMessage was changed to sendMsg - onRecvMessage was changed to onRecvMsg - Broadcasting of message for multiple entities is available. **エンティティに設置するカメラの設定方法 [#wae24a4b] -世界ファイルでのカメラの設置方法の修正。 以下のように設定 ** Configuration of Camera [#w6443648] - Configuration of camera is changed to as follows: <camera id="1" direction ="0 0 1" position="0.0 10.0 0.0" fov="40" aspectRatio="1.5"/> **サービスプロバイダ [#q00f7453] -コントローラでサービスプロバイダを使用する場合connectToService("service_name") により一度サービスに接続して初めてサービスが利用可能となる。 -サービスはコントローラからメッセージを受信することが可能。 -サービスをプラグインとしてビューワーに登録し、ビューワーから起動することが可能。 ** Service Provider [#ceb2d3a8] - connectToService("service_name") should be called before using a Service Provider in controller. - Service can receive messages from controller - Service can be registered as plug-in at the SIGViewer. The service can be executed from the SIGViewer after the registration. [[Version Information]] #counter